RIS-KIT-FULL-3 - Speed Sleeve™ Rapid Install Kit - Complete Kit includes Base Guide Unit with 0.50", 1.00" and 1.5" Dies WITH 3FT TUBES

Speed Sleeve™ - Rapid Sleeving Install Tool

Applying Flexo® braided sleeving by hand to wires and cables can be a time-consuming process, especially in your production environment. The Techflex® Speed Sleeve™ can improve the process for repetitive jobs and long runs. The easy-to-use tool is designed to accelerate the process. The practical Speed Sleeve™ base unit can accommodate any tube length and mount to a workbench, miter stand, or similar surface. Speed Sleeve™ fits sleeving directly to harnesses for a neat, snug, and efficient application. You can customize the tubes and layout to best suit your job. Your production team will save precious time and your wiring will be protected for a lifetime.

Download The Speed Sleeve® Instruction Booklet

Please Note: The Work Bench is not included.

Instructions On How to Use Your Speed Sleeve® Installer

• Your Wire Harness
• Speed Sleeve™ Rapid Install Kit of choice
• Tube (if not included in your chosen kit)
• Appropriate Flexo® Braided Sleeving for the application
• Workbench, Sawhorse, or miter stand to place Speed Sleeve®
• Allen Wrench in the appropriate sizes for bolts needed for the flange and pulley
• The Speed Sleeve™ Rapid Install Kit includes grade A steel square head screws that are ½”- 13 thread size, 3” long, and ½” – 13 X 1” fully threaded hex cap screws grade 5 coarse med. carbon plain.

• Secure Speed Sleeve™ to a flat surface, whether a workbench, sawhorse, or miter stand.
• Place the base unit with green pulleys on one end of workbench, sawhorse, or miter stand.
• Place the tool’s flange end on the opposite side of the green pulley portion of the tool, with each piece parallel to one another.
• Clamp one side of the tube between the green pulleys and insert the other into the unit’s flange side.

• Push the sleeving onto the tube, with the sleeving feeding itself as it is pushed.
• Bunch sleeving onto tube accordion style until entire tube is filled.
• Once entire length of sleeving needed is fed onto the tube, tighten the green rollers on the pulley portion of the tube to lock sleeving into place.
• Ensure sleeving has some movement to facilitate steps with transferring it onto wire harness.

• Push the sleeving onto the tube, with the sleeving feeding itself as it is pushed.
• Bunch sleeving onto tube accordion style until entire tube is filled.
• Once entire length of sleeving needed is fed onto the tube, tighten the green rollers on the pulley portion of the tube to lock sleeving into place.
• Ensure sleeving has some movement to facilitate steps with transferring it onto wire harness.